HP LaserJet 4050 Printer series - Manual (Page 217)

EN
Control Panel Menus B-17
RAM DISK=OFF OFF
ON
AUTO Determine how the RAM disk is configured.
This item appears only if there is no optional
hard disk installed and the printer has at least
16MB of memory.
OFF : The RAM disk is disabled.
ON : The RAM disk is enabled. Configure the
amount of memory to be used through the
following item:
RAM DISK SIZE .
Note
If the setting is changed from OFF to ON or from
OFF to AUTO , the printer will automatically
reinitialize when it becomes idle.
RAM DISK SIZE=xxxK 0K and up
(This value
depends on the
amount of
installed
memory.)
Determine the size of the RAM disk. This item
appears if
RAM DISK = ON or AUTO .
Press [-Value+] to change settings by
increments of 100.
Note
This setting cannot be changed if RAM DISK=
AUTO . Changing this value will cause the printer
to reinitialize when it becomes idle.
JAM RECOVERY=
AUTO AUTO
ON
OFF Determine how the printer behaves when a
paper jam occurs.
AUTO : The printer automatically selects the
best mode for printer jam recovery (usually ON ).
This is the default setting.
ON : The printer automatically reprints pages
after a paper jam is cleared.
OFF : The printer does not reprint pages
following a paper jam. Printing performance
might be increased with this setting.
MAINTENANCE
MESSAGE=OFF OFF This item appears only after the PERFORM
PRINTER MAINTENANCE message displays.
OFF : The PERFORM PRINTER MAINTENANCE
message will be cleared and will not be
displayed again until the next maintenance is
due.
The message should not be turned off unless
the printer maintenance has been performed.
If the required maintenance is not performed,
the printer’s performance will degrade.
For more information, see page 87. To order
the Printer Maintenance Kit, see page 11.
Configuration Menu (Continued)
Item Values Explanation