HP LaserJet 4050 Printer series - Manual (Page 211)

EN
Control Panel Menus B-11
UNIT OF MEASURE=
INCHES
(110V printers)
or
MILLIMETERS
(220V printers)
INCHES
MILLIMETERS This item appears only when CONFIGURE
CUSTOM PAPER=YES . Select the unit of
measurement for the custom paper size.
X DIMENSION=
8.50INCHES
(110V printers)
or
216 MILLIMETERS
(220V printers)
For supported paper
sizes, see page A-3 This item appears only when CONFIGURE
CUSTOM PAPER=YES . Select the dimension
to be fed into the printer (short edge).
Y DIMENSION=
14.00 INCHES
(110V printers)
or
356 MILLIMETERS
(220V printers)
For supported paper
sizes, see page A-3 This item appears only when CONFIGURE
CUSTOM PAPER=YES . Select the other
dimension (long edge).
FORM=60 LINES
(110V printers)
or
64 LINES
(220V printers)
5 to 128 Sets vertical spacing from 5 to 128 lines for
default paper size. Press
[- Value +] once
to change the setting by increments of 1, or
hold down
[- Value +] to scroll by
increments of 10.
ORIENTATION=
PORTRAIT PORTRAIT
LANDSCAPE Determine the default orientation of print on
the page.
Note
It is best to set the page orientation from the
printer driver or software application.
(Driver and software settings override
control panel settings.)
PCL FONT SOURCE=
INTERNAL INTERNAL
SOFT
SLOT 1, 2,
or 3
INTERNAL : Internal fonts.
SOFT : Permanent soft fonts.
SLOT 1, 2, or 3 : Fonts stored in one of
the three DIMM slots.
Note
It is best to set the font source from the
printer driver or software application.
(Driver and software settings override
control panel settings.)
Printing Menu (Continued)
Item Values Explanation