HP LaserJet 4050 Printer series User Manual
Page 152
130
Chapter 4: Problem Solving
EN
The print job has been
properly sent, but the
printer will not print.
If the connection is broken before the entire print job has been
transmitted to the printer (printing has not yet started), the printer
may not print any of the job. Press
[Cancel Job]
to clear the printer’s
memory. Then, reposition the portable device within the range of
operation described in the user guide for the HP Fast InfraRed
Receiver, and print the job again.
The FIR status
indicator turns off
during transmission.
The connection might have been broken. Press
[Cancel Job]
to
clear the printer’s memory. Then, reposition the portable device
within the range of operation described in the user guide for the
HP Fast InfraRed Receiver, and print the job again.
PS print job will not
print.
Check the configuration in the PostScript Tab of Windows: check
that Protocol is set to AppleTalk and Binary Data is not selected.
Troubleshooting HP Fast InfraRed Receiver Problems (Continued)
Item
Explanation