ADTRAN ATLAS 800PLUS - Manual (Page 122)

Chapter 8. Updating Firmware
8-6 ATLAS _ 800 PLUS User Manual 61200226L1-1
15. The Previous Update Status field indicates the results of the last firmware
update for the particular slot chosen. If a firmware update has not been
attempted for the particular slot, the Previous Update Status will display
Has
not been attempted .
16. After completing the configuration of all the above parameters, select the
Begin Firmware Update field to activate the update process. This field requires
user confirmation and will set up the module to initiate a TFTP upload with
the specified network server. Once the update process begins, this field
changes to
Cancel Update to allow you to cancel the current update in
progress.
17. During the TFTP upload process, various status messages will be provided in
the Current Update Status field to indicate progress. These are described as
follows:
18. When the update process has completed successfully, the menu screen will
display Idle in the Current Update Status field and Module Update Complete
in the Previous Update Status field. In the event an error occurred during the
update process, the Previous Update Status field will display the appropriate
error message. Please go to step 7 and attempt the update process again. If
the same error occurs, please contact ADTRAN Technical Support.
19. If the update of the module was successful, the module will either restart
immediately and resume operation or restart at the specified time and day of
the week, depending on your selection.
20. To update additional modules, go to Step 6 and select the appropriate slot.
TFTP -
Contacting Server Indicates communication with the TFTP
network server is trying to be established
with the specified server address in the
TFTP Server IP Address field.
TFTP -
Beginning TFTP Transfer Indicates communication with the TFTP
network server has been established and
the update file is being transferred
between ATLAS and the TFTP network
server.
TFTP - Completed Indicates the ATLAS product successfully
received the update file.
TFTP -
Error: File Not Found Indicates the TFTP network server was
unable to locate the specified file name or
path in the TFTP Server Filename field.
TFTP -
Error: Access Violation
Indicates the TFTP network server denied
ATLAS access to the given update file
name and path. Please verify
appropriate user rights are selected for
the specified path.
TFTP -
Error: Illegal Operation An unknown operation was detected by
ATLAS when transferring the update file
from the TFTP network server.
TFTP -
Error: User aborted Indicates the user selected Cancel Update
to abort reception of the update file from
the TFTP network server.