ADTRAN ATLAS 800PLUS User Manual

Page 41

Advertising
background image

Chapter 3. Operation

61200226L1-1

ATLAS

_

800

PLUS

User Manual

3-7

through the terminal menus. See “Access Passwords” on page 5-16 for details.
The Telnet session will time out and display the Login prompt after a pre-defined
time that is set in the Session Timeout option (see “Session Timeout” on page 5-12
for details).

Use the Max Telnet Sessions option to define the number of Telnet sessions that
can be active at one time (see “Max Telnet Sessions” on page 5-13 for details).

Microsoft Telnet version 1.0 does not implement full VT-100 emulation. How-
ever, many commercial Telnet clients for Microsoft Windows exist which fully
implement VT-100. In addition, a freeware client which is recommended for op-
timum performance is delivered with the ATLAS

_

800

PLUS

. See “VT-100” on

page 10-3 for details.

For detailed information on the commands available during a Telnet session, refer
to Chapter 5, “Using the Terminal Menu” on page 5-1.

VT-100 Operation

An EIA-232 serial connection is available via the chain-in port on the rear panel of
the ATLAS

_

800

PLUS

. The ATLAS

_

800

PLUS

provides the front panel menus to a

VT-100 type terminal. Follow these steps to set up the ATLAS

_

800

PLUS

for VT-100

terminal mode:

1.

Set the baud rate on the VT-100 terminal to 9600 baud (8/N/1).

2.

Use the front panel to set the ATLAS

_

800

PLUS

baud rate to match the terminal

baud rate. Select

2) CONFIG, S0) SYSTEM, 2) CHAIN PORT,

then

1) BAUD

RATE

.

3.

Use the ADTRAN-provided VT-100 terminal adapter to connect the COM
port of a VT-100 compatible terminal, or equivalent, to the eight-pin modular
jack labeled

CONTROL

on the rear of the unit. This connection provides both

local and remote configuration.

4.

Repeatedly press

Enter

on the front panel until the Login Menu appears.

After connecting a VT-100 terminal or a computer running VT-100 terminal-emu-
lation software to this port, you may need to press

Ctrl-R

to refresh the display.

Refer to “Using the Terminal Menu” on page 5-1 for detailed information on
using the terminal menus.

When you begin the VT-100 session, you will be prompted for a password. The
default password is

password

(which is a Level 0 superuser password). You can

change this password using the Access Passwords option, which is only accessible
through the terminal menu. See “Access Passwords” on page 5-16 for details.

For detailed information on the commands available during a VT-100 session,
refer to Chapter 5, “Using the Terminal Menu” on page 5-1.

Advertising