ADTRAN ATLAS 800PLUS - Manual (Page 32)

Chapter 2. Installation
2-6 ATLAS _ 800 PLUS User Manual 61200226L1-1
Ethernet 10BaseT Connection
The 10BaseT port (RJ-48C) provides an Ethernet LAN connection, which is used
for TFTP, SNMP, and Telnet connection. See Table 2-4 on page 2-6 for the pinout.
Connection
The network connection is as follows:
MON (Monitor)
The MON test jack provides a bridged access jack for non-intrusive monitoring of
the T1 circuits receiving data. When connected to this jack, the test equipment
should be configured for a bridged termination.
Table 2-3. Network Pinout
PIN NAME DESCRIPTION
1 R1 RXDATA-RING Receive data from the network
2 T1 RXDATA-TIP Receive data from the network
3 UNUSED —
4 R TXDATA-RING Send data toward the network
5 T TXDATA-TIP Send data toward the network
6,7,8 UNUSED —
Connector type (USOC) RJ-48C
Part number AMP# 555164-2
Table 2-4. Ethernet 10BaseT Pinout
PIN NAME DESCRIPTION
1 TX1 Transmit Positive
2 TX2 Transmit Negative
3 RX1 Receive Positive
4 & 5 UNUSED —
6 RX2 Receive Negative
7 & 8 UNUSED —