ADTRAN ATLAS 800PLUS - Manual (Page 67)

Chapter 5. Using the Terminal Menu
61200226L1-1 ATLAS _ 800 PLUS User Manual 5-15
Trap Transmission
Write security: 3; Read security: 5
Enables and disables SNMP trap transmission.
Authen Trap Transmission
Write security: 3; Read security: 5
Enables and disables the authentication failure trap.
Traps Destination
Write security: 3; Read security: 5
Defines the destination for SNMP traps. The following options are available:
Trap Filtering
You can set filters for the system controller, the switchboard, the
Quad Nx56/64 module, the Quad T1/PRI module, and ISDN events.
If a trap event occurs and if the trap’s severity level is equal to or
more severe than the trap type’s current threshold setting, that event
is sent as an SNMP trap. (Refer to the ATLAS
_ 800
PLUS
MIB for a list-
ing of all traps and their severity levels.)
You can set the following threshold levels for the available selections:
This option... Does this...
IP Address Specifies the IP address of the network manager.
Privileges Defines Get (read-only) and Get/Set (read and write)
privileges.
Get Name Defines the community name for Get access. This value
must match the Get name defined on the network
management station. Public is the default name.
Set Name Defines the community name for Set access. This value
must match either the Get or Set name defined on the
network management station. Public is the default name.
This option... Does this...
IP Address Identifies the IP address to which the network manager
sends traps.
Community Defines the community name for trap destinations. This
name must match the community name defined at the
network management station.
Trap Filtering Sets the minimum severity level required for a system
event to generate an SNMP trap. (See also ”Trap
Filtering” below.)
• Disabled • Major • Warning • Info
• Critical • Minor • Normal