Vaisala Hydromet Data Collection Platform - Manual (Page 107)

Chapter 3 _______________________________________________________ AWS Client Software
VAISALA______________________________________________________________________ 105
Sleep Command
The Sleep command is used for powering down the QML logger (in
order to use the Sleep command, first select the Sleep command
enabled check box in the Options menu). There are two options for
powering down the logger: powering it down completely or powering it
down but leaving the battery charging function active. To power down
the logger, proceed as follows:
1. On the Maintenance menu, select Sleep.
a. To power the logger down completely, select Total.
b. To power the logger down leaving the battery charging
function active, select Charge.
The logger is powered down; to power it up again, use the Wakeup
command (see section
Wakeup Command on page 105 ).
Wakeup Command
The Wakeup command is used for powering the QML logger up after
it has been set to a power-saving mode.
To issue the Wakeup command to the logger, select Wakeup on the
Maintenance menu.