Vaisala Hydromet Data Collection Platform - Manual (Page 74)

User's Guide ______________________________________________________________________
72 ___________________________________________________________________M210784EN-E
Sensor Status List
Table 13 Sensor Status List
Value Description Notes
0 Sensor is working properly (OK).
1 Not measured yet.
2 Interface is not initialized. 1
1. Value is available only for sensors with a serial interface.
3 Communication timeout has occurred. 1
4 Unknown data is received. 1
5 Communication is functioning, but the sensor reports
errors. Use sensor's own service interface to find out
the cause. 1
6 Sensor communication is paused because service
connection is opened. 1
7 Message sequence numbers are overlapping in the
Autotrac satellite transceiver interface. 1
8 ... 19 Not available.
20 Excitation failure is caused by overload in the
excitation output. 2
2. Value is available only for sensors with a conventional, that is, analog or
counter/frequency, interface.
21 The input voltage is out of range or the A/D conversion
has failed due to an internal error. 2
22 Sensor is disconnected or the connection cables are
broken. 2
23 Sensor output exceeds the min/max limits defined in
the Measurements view. 2
24 Change in sensor output has exceeded the maximum
step defined in the Measurements view. 2
25 An internal configuration error has occurred. 2
26 Error in reference measurement, which is usually
caused by damaged sensor/logger or electrical
interference. 2
27 Internal voltage error occurred or the logger is
damaged. 2
28 PMT16 calibration data error. 2
29 Data is invalid for unspecified reason. 2
30 The measurement or the sensor has been manually
disabled.
99 Sensor status is not supported.