Entering values for manual sensors, Viewing manual sensors in aws client – Vaisala Hydromet Data Collection Platform User Manual
Page 78
User's Guide ______________________________________________________________________
76 ___________________________________________________________________M210784EN-E
Entering Values for Manual Sensors
Before you can manually enter data to the QML logger using the AWS
Client software, you must create and configure manual sensor(s) in
Lizard Setup Software. For instructions on creating a manual sensor,
see Chapter 3, Configuring Modules and Sensors, in Vaisala
HydroMet™ Data Collection Platform User’s Guide, Volume 3.
Viewing Manual Sensors in AWS Client
For each manual sensor included in your setup, you can view
information on the sensor’s status, the type of values for which the
sensor is used, and the range of valid values for the sensor. To view the
manual sensor information, proceed as follows:
1.
On the Settings menu, select Manual Sensors. The list of
configured manual sensors is displayed.
2.
Select the sensor on which you want to view information from the
list.
3.
Select Edit. The information on the sensor is displayed as shown
in
.
NOTE
New sensor calibration values are taken into use in the QML logger
after a reset with, for example, the Reset command. For further
information on resetting the QML logger, see section
.