Vaisala Hydromet Data Collection Platform - Manual (Page 122)

User's Guide ______________________________________________________________________
120 __________________________________________________________________M210784EN-E
When you no longer need the capture files, you can delete them from
your PC. The capture file is format yyMMddHHmmSS.log, which name
is a time stamp of the file’s creation. The file is saved in the Trace log
directory you have defined in the Options window.
In problem situations, give the following commands: battery, errors,
spset, SYSINFO, and warnings. When Capture all is selected, the
results are saved into a file for future use.
Opening a Service Connection
through QML Logger
The command interface of the modem or a serial sensor can be accessed
through the QML logger, for example, to send the AT commands
manually. To control the modem or sensor directly, open the service
connection to the logger, and, for example, when the device is
connected to the DSU232’s first communication port at the module
place MOD1, type open DSU232_0_0. To terminate this operation,
type close. While the direct connection to the modem or sensor is open,
any automatic operation through the connected port is blocked.
Parameters for the open command are presented in Table 26 on page
121 . The parameter in column "Parameter" identifies the serial
connector and can be used with all MAWS versions. In MAWS version
8.00 and later, the parameter in column "Alias" can be used, as well.
Information concerning the correct connector can be obtained in Lizard
Setup Software under I/O Connections in the Devices, Equipment,
and Additional sensors views.
NOTE AWS Client software keeps recording terminal connection history
until the Trace log on option is cleared. Do not neglect to clear this
option once you have recorded enough messages; otherwise, log files
will accumulate over time and unnecessarily reserve your disk space.