Vaisala Hydromet Data Collection Platform - Manual (Page 34)

User's Guide ______________________________________________________________________
32 ___________________________________________________________________M210784EN-E
Data Collection Software
The QML logger works based on what is known as a setup. A setup is
a set of parameters that tells the logger what to measure, log, calculate,
and report. Measured data is stored in the daily log files that can be
downloaded to a PC and viewed using display software. The delivery/
project-specific data reports can be configured to collect data from
weather stations by data collection systems.
Usually, a delivery-specific setup has been loaded in the QML logger
program memory at the factory. Therefore you simply need to connect
the sensors, connect communication lines, and supply power. Your
station will then start operating, that is, making measurements, doing
calculations, and sending reports. Normally, the provided example
setups, such as the Basic setup, need to be modified according to
delivery-specific requirements. The setups are modified using Lizard
Setup Software.
On the delivery CD-ROM, you will find several setup examples. The
delivered setups will suit typical needs, but you may want to make
changes to them. For reconfiguring the setup files or making entirely
new ones, refer to Vaisala HydroMet™ Data Collection Platform
User’s Guide, Volumes 2 and 3.
The log files downloaded to a PC can be viewed using AWS Client
software. Alternatively, the data values can be viewed with YourVIEW
Basic Display Software or Vaisala Digital Displays.
Operating Software
The embedded operating software runs in the QML logger. Access to
the operating software commands can be gained using AWS Client
software.
AWS Client Software
Vaisala AWS Client software is used for downloading data log files,
issuing QML logger commands and setting its parameters, and
performing maintenance tasks on the QML logger. The supported
connection types to the QML logger are serial line, dial-up connections
using a modem, and TCP/IP socket connections. The logger measures
sensor data and stores it in log files. With AWS Client, you can
download these files to your PC and view them.