Vaisala MMT162 - Manual (Page 30)

User's Guide ______________________________________________________________________
28 __________________________________________________________________ M210934EN-C
Configuring Serial Line Operation
Set Serial Line Settings
Use the serial line command SERI [b p d s] to set communication
settings for the user port.
SERI [b p d s]<cr>
where
b = Bit rate (110, 150, 300, 600, 1200, 2400, 4800, 9600,19200,
38400)
p = Parity (n = none, e = even, o = odd)
d = Data bits (7 or 8)
s = Stop bits (1 or 2)
Example:
seri 600 n 8 1
600 N 8 1
You need to reset the transmitter to activate the new communication
settings set with the SERI command.
The settings can be changed one parameter at a time or all parameters at
once:
seri o changing parity only
4800 O 7 1
seri 600 n 8 1 changing all parameters
600 N 8 1
You can use the SERI command to change/view the user port settings
even if you are currently connected to the service port.