Campbell Scientific CC5MPX and CC5MPXWD Digital Network Cameras - Manual (Page 111)

20-1
Section 20. Backplate Removal
Procedures
It will be necessary to remove the backplate for the following reasons:
• Access to the SD memory card
• Change Internal Jumper Positions
• Replace Desiccant
• Inspect O-rings
If the camera is powered up and operating (LED is flashing), properly
shutdown the camera by holding down the setup button for more than 10
seconds continuously. Alternatively the Shutdown button can be used from the
Live Video Home page of the camera. Once the camera LED stops flashing,
remove the CC5MPX from any power supply and disconnect any attached
cabling.
To remove the backplate, first remove the six Philips screws located along the
perimeter of the cameras backplate (see FIGURE 20-1). Note that there are
two washers that are included with the protective cover chains of the button
cap and the RJ45 cap.