Campbell Scientific CC5MPX and CC5MPXWD Digital Network Cameras - Manual (Page 87)

12-1
Section 12. Device Configuration Utility
The Device Configuration Utility can be used to change settings in the
CC5MPX. The Device Configuration Utility software can be downloaded, at
no charge, from the Campbell Scientific website.
Using the Device Configuration Utility
• Connect the camera to the serial port of a PC using the DB9M-TERM as
shown in Section 9, RS-232 Communications. The A200 Sensor to PC
Interface can be used in lieu of the DB9M-TERM.
• Once the camera is powered up (this typically takes 90 seconds), you
should observe that the LED flashes. If the LED does not flash you may
have to press the Setup button to exit the camera from a low powered
mode.
• Select the CC5MPX from the device list (see FIGURE 12-1) and Connect
to the camera.
o Normally the camera is set to a baud rate of 115200 bps. If the
baud rate is set to something else, select the appropriate baud rate
• Once connected to the CC5MPX, use the tabs (see FIGURE 12-2) to
navigate and configure the camera.
FIGURE 12-1. CC5MPX Device Configuration Option