Campbell Scientific CC5MPX and CC5MPXWD Digital Network Cameras - Manual (Page 20)

Section 3. Getting Started
3-6
FIGURE 3-5. Web Interface Live Video Home Page
If you select a video format to display from the Video Display Size drop down
box, you should be prompted to install an Active X control. Your browser may
be configured by default to block pop-ups. You will need to enable the pop up
for the camera.
3.5 Setup Using Device Configuration Utility
Campbell Scientific provides a free software program called the Device
Configuration Utility that supports the configuration of a variety of equipment.
The CC5MPX can also be configured with the Device Configuration Utility.
Please visit Campbell Scientific’s web site to ensure that you have the most
recent version of the utility.
The CC5MPX ships from the factory with the communication lines configured
for RS-232. The green wire on the cable is the CC5MPX RS-232 TX (output)
line, the white wire is the CC5MPX RS-232 RX (input) line and connection
will also need to be made from the CC5MPX black ground to the RS-232
ground.
The CC5MPX comes with a DB9M-TERM that facilitates the connection of
the CC5MPXCBL1-L cable to a 9-pin RS-232 connector. See Section 4 for
wiring details.
When power is first applied to the camera, the LED will turn on and remain
steadily on for about 90 seconds. Once the LED starts flashing, the camera has
initialized properly and is ready for operation.