Campbell Scientific CC5MPX and CC5MPXWD Digital Network Cameras - Manual (Page 18)

Section 3. Getting Started
3-4
You should record the existing settings that are used on the computer to restore
the connection back once the CC5MPX setup is completed. In the screen
shown above, the computer is set to Obtain the IP address automatically which
is quite common.
At this point you will also want to disconnect your computer from the network
and connect it directly to the CC5MPX camera. You do not need to use a
crossover cable as the CC5MPX has an auto MDIX feature that will allow the
camera to automatically connect with or without a crossover cable.
Change the settings by assigning a manual IP address. In this case, we will
assign an address of 192.168.1.91 with a Subnet mask of 255.255.255.0. The
default gateway could also be set to 192.168.1.1.
FIGURE 3-4. IP Address Configuration
Click OK.