Campbell Scientific CC5MPX and CC5MPXWD Digital Network Cameras - Manual (Page 30)

Section 5. Camera Hardware Description
5-2
If a permanent Ethernet connection is required outdoors or if a connection is
required in wet or harsh locations, the CC5MPXCBL2-L Environmentally
Rated Ethernet cable must be used.
The maximum cable length for the Ethernet cable is 70 m (230 ft).
The CC5MPX does not support the PakBus communication
protocol over Ethernet.
5.2 Power I/O Connection
The CC5MPXCBL1 cable must be attached to the Power I/O connector for
camera operation. It is the only means to supply power to the camera. The
connector that connects to the Power I/O connector provides a weather tight
connection.
When making the cable connection to the camera the notch positions should
always be lined up and care should be taken to not cross thread the connector.
5.3 Setup Button/Status LED
The Setup button is located behind a protective metal cap on the camera. The
Setup button also contains an integrated Status LED for user feedback.
To access the LED unscrew the protective cap to expose the Button/LED. It is
highly recommended to place the protective cap back on for improved
environmental protection.
5.3.1 Status LED
The Status LED located in the center of the button provides some useful
diagnostic information about the camera. The following table describes the
LED behavior.
NOTE