Campbell Scientific CC5MPX and CC5MPXWD Digital Network Cameras - Manual (Page 112)

Section 20. Backplate Removal Procedures
20-2
FIGURE 20-1. Backplate View
After the screws are removed, gently pull the backplate out (see FIGURE
20-2). The backplate will still be attached to the camera with the wires (see
FIGURE 20-3). Do not remove the wires. Pivot the backplate to the left side
of the camera. You will now have access to the inside of the camera.
When replacing the backplate, ensure that the O-ring is still seated properly on
the backplate (see FIGURE 19-2). This is very important as the O-ring is
required to properly seal the camera.
Screw
Screw
Screw
with Chain
and
Washer
Screw
with Chain
and
Washer
Screw Screw