Section 5. camera hardware description, 1 ethernet rj-45 connection, Camera hardware description -1 – Campbell Scientific CC5MPX and CC5MPXWD Digital Network Cameras User Manual
Page 29: Ethernet rj-45 connection -1, Figure 5-1. cc5mpx connector layout -1
5-1
Section 5. Camera Hardware
Description
FIGURE 5-1. CC5MPX Connector Layout
5.1 Ethernet RJ-45 Connection
The RJ45 connector on the camera is meant to interface the CC5MPX with
either a network router, cellular modem, or directly to a laptop.
If a permanent Ethernet connection is not required for an outdoor environment,
then the protective cap must be securely attached to the Ethernet connector to
provide an environmental seal.
When the protective cap is removed, a standard cable with an RJ45 connector
can be used to connect the camera to another device in an indoor environment
or temporarily outdoors if weather permits.
Remove cap to connect
Ethernet cable (typically
the CC5MPXCBL2)
Remove cap to press Setup
button or view Status LED
Connector for the
CC5MPXCBL1
Power I/O Cable