Campbell Scientific CC5MPX and CC5MPXWD Digital Network Cameras - Manual (Page 39)

Section 7. Camera Operation Using Web Browser Interface
7-3
removed from a camera that is actively collecting and storing images or video.
It will completely shut down for a period of 10 minutes and ensure the memory
card is not corrupted. An alternate way of shutting down the camera is to hold
the Setup Button down for a period of at least 10 seconds.
Information features on the Live Video page include:
• Motion Detect Indicator
o Turns from green to red when motion is detected.
o This will indicate even if the motion capture is not enabled.
• External Trigger Status
o Reflects the state of the External Trigger signal on the Power I/O
cable.
• System Status
o Indicates the SD card presence or absence and system messages.
• Internal board temperature value
o When fully on, the internal temperature can be 10° to 15°C (18° to
27°F) above ambient.
• Focusing numbers
o Facilitates focusing (see section Using the Focusing Number)
• Date and Time
The Live video page, as well as every other page, also contains a navigation
bar with tabs that allow navigation to the other CC5MPX web pages. These
are called Page Tabs.
Any configuration changes made in the web interface of the
CC5MPX must be “Submitted” in order to save and activate
changes. If you navigate away from the page before submitting
changes they will be lost.
7.2 Network Configuration
To access the main Network Configuration page, simply click the Network
page tab.
When you first enter the Network page, you will receive the following prompt
as a warning (FIGURE 7-3). If changes are made to the camera that affects the
access to the web interface, you will need to restart the browser with the new
configuration.
NOTE