Sony HAP-S1 - Manual (Page 91)

HDD AUDIO PLAYER
HAP-S1
Connecting the HDD AUDIO PLAYER to a network manually
You can enter the IP address and other network information manually to connect the HDD AUDIO PLAYER
to a wired network. Make sure that you have information such as the IP address, subnet mask, default
gateway and primary/secondary DNS in advance.
1. Select [Settings] - [Network Settings] - [Internet Settings] from the Home screen.
2. Select [Wired Setup].
3. Select [Custom] on the IP address settings confirmation screen.
4. Select [Specify IP Address].
An input screen for information such as IP address, subnet mask and default gateway appears.
5. When the IP address is surrounded by a white box, push the jog dial in.
An input segment appears for the IP address.
6. Enter the IP address.
Turn the jog dial to select a value and push it in to enter the selection. When you push the jog dial
in, the input segment moves to the next number. When you push the jog dial in at the furthest right
segment, the IP address is confirmed and the whole IP address is surrounded by the white box
again.
7. If you also want to enter a subnet mask, default gateway or primary/secondary DNS, select the item
you want to enter.
Repeat the same operations as step 6.
When the input is completed, a screen showing the network settings information appears.
8. Select [Next].
A confirmation message for the LAN cable connection appears.
9. Select [Save & Connect].
The HDD AUDIO PLAYER starts connecting to the network.
10. When the network connection is completed, confirm the message about the wired LAN and Internet
access on the screen and then select [OK].
Help Guide
How to Use
91