Sony HAP-S1 - Manual (Page 95)

HDD AUDIO PLAYER
HAP-S1
Method 1. Setting up a network connection using the WPS push button configuration method
If your wireless LAN router/access point has a WPS button, you can easily connect the HDD AUDIO
PLAYER to a Wi-Fi (wireless LAN) network.
If your wireless LAN router has an AOSS button or other easy setup button, it may support WPS. Check
the operation manual of your wireless LAN router/access point for details.
1. Select [Settings] - [Network Settings] - [Internet Settings].
2. Select [Wireless Setup].
3. Select [Wi-Fi Protected Setup (WPS)].
4. Select [Start] and then press the WPS button on your wireless LAN router/access point.
The HDD AUDIO PLAYER starts searching for the access point.
5. When the connection is made, confirm the registration completion message that appears on the
screen and then select [Next].
6. When the network setup is completed, select [OK] on the screen.
Note
If you cannot connect to a network correctly, the following reasons are possible. Try the connection
again or use another connection method.
You pressed the WPS button more than two minutes after selecting [Start] in step 4.
The WPS button may have to be pressed and held for about two minutes (depending on the router).
You cannot cancel the connection after the HDD AUDIO PLAYER has started connecting to the network.
Do not turn the power off while the HDD AUDIO PLAYER is connecting to the network.
Hint
For details on the name and position of the WPS button on your wireless LAN router/access point, refer
to the operating manual of the router/access point.
Notes on use
4-472-853-11(1)
Copyright 2013 Sony Corporation
Help Guide
How to Use
95