Sony DCR-IP1 - Manual (Page 104)

Additional Information 104
camcorder to the wall outlet using the supplied
AC Adaptor during the operation.
1 Slide the POWER switch up to
(CHG)OFF.
2
Remove your camcorder from the
Handycam Station, eject the cassette and
“Memory Stick Duo” from your
camcorder, then disconnect cables other
than that of the AC Adaptor from your
camcorder.
3
Slide the POWER switch repeatedly to
select the PLAY/EDIT mode while
pressing DISPLAY/BATT INFO for
about 5 seconds on your camcorder, then
press and hold DISPLAY/BATT INFO
until the [CALIBRATION] indicator
appears.
4
Touch the “×” displayed on the screen
with the corner of the “Memory Stick
Duo.”
The position of the “×” changes.
If you did not press the right spot, follw the
whole procedure above again.
b Note
• You cannot calibrate the LCD screen if you have
rotated the LCD panel and set it with the LCD screen
facing out.
On cleaning the casing
When the casing is soiled, clean the camcorder
body with a soft cloth lightly moistened with
water.
Avoid the following as the finish may be
damaged.
– Using solvents such as thinner, benzine,
alcohol, a chemical cloth, or volatile material
like an insecticide.
– Leaving the case in contact with rubber or
vinyl objects for a long period of time.
About care and storage of the lens
• Wipe the surface of the lens clean with a soft
cloth in the following instances:
–When there are fingerprints on the lens
surface.
–In hot or humid locations.
–When the lens is exposed to salty air such as
at the seaside.
• Store in a well-ventilated location subject to
little dirt or dust.
• To prevent mould periodically clean the lens
as described above.
It is recommended you operate your camcorder
about once a month to keep it in an optimum
state for a long time.
To charge the built-in rechargeable
button-type battery
Your camcorder has a built-in rechargeable
battery to retain the date, time, and other
settings even when the POWER switch is set to
(CHG)OFF. The built-in rechargeable battery is
always charged while you are using your
camcorder but it will get discharged gradually if
you do not use your camcorder. The
rechargeable battery will be fully discharged in
about 3 months if you do not use your
camcorder at all. However, even if the built-in
rechargeable battery is not charged, the
camcorder operation will not be affected if you
are not recording the date.
Procedures
Connect your camcorder to a wall outlet using
the supplied AC Adaptor, and leave it with the
POWER switch set to (CHG)OFF for more than
24 hours.
CALIBRATION