Sony DCR-IP1 - Manual (Page 19)

Getting started
Ge
ttin
g
sta
rte
d
19
3
Lightly push the cassette compartment
in with the cassette lid.
The cassette compartment automatically
slides back in.
4
Close the cassette lid.
To eject the cassette
1 Slide the lever and open
the cassette lid.
The cassette compartment automatically
comes out.
2 Take out the cassette.
3 Lightly push the cassette compartment
in with the cassette lid.
The cassette compartment automatically
slides back in.
4 Close the cassette lid.
Inserting a “Memory Stick Duo”
For details on the “Memory Stick Duo,” see
page 97.
b Note
• You can use only a “Memory Stick Duo,” which is
about half the size of an ordinary “Memory Stick,”
in your camcorder (p. 97). Do not try to force any
other type of “Memory Stick” into the “Memory
Stick” slot.
Insert the “Memory Stick Duo” with the b
mark in the bottom left corner facing
down until it clicks.
To eject a “Memory Stick Duo”
Lightly push the “Memory Stick Duo” in once.
b Notes
• If you force the “Memory Stick Duo” into the
“Memory Stick” slot in the wrong direction, the
“Memory Stick” slot may be damaged.
• Do not insert anything other than a “Memory Stick
Duo” into the “Memory Stick” slot. Doing so may
cause a malfunction of your camcorder.
• When the access lamp is lit or flashing, your
camcorder is reading/writing data from/to the
“Memory Stick Duo.” Do not shake or knock your
camcorder, turn the power off, eject the “Memory
Stick Duo,” or remove the battery pack. Otherwise,
image data may be damaged.
OPEN/EJECT
b mark
Access lamp
Lightly push in once.