Sony DCR-IP1 - Manual (Page 33)

Recording
Re
cord
ing
33
MENU, then select it from the (PICT.
APPLI.) menu.
4
Touch the desired effect, then touch
.
5
Press START/STOP.
The fader indicator stops flashing and stays
lit up, then disappears when the fade is
complete.
To cancel the FADER
Follow steps 2 and 3, then touch [OFF] in step 4.
b Note
• You cannot use FADER together with:
– Color Slow Shutter
– Digital effect
z Tip
• You can also select the fade-in effect while
recording. When you stop the recording, the screen
turns blue to store its last image, from which you can
fade into the continuing recording.
Fading in from a still image on the
“Memory Stick Duo” — Memory
overlap
You can fade in from the still image on the
“Memory Stick Duo” to the movie currently
being recorded on the tape.
1
Check that you have a “Memory Stick
Duo” with the still image to be
superimposed and a tape in your
camcorder.
2 Slide the POWER switch to select the
CAMERA-TAPE mode.
3 Touch .
4 Touch MENU.
5 Select the (PICT.APPLI.) menu,
then [ OVERLAP] using / ,
then touch .
The recorded still image on the “Memory
Stick Duo” appears on the thumbnail
screen.
6 Touch (previous) / (next) to
select the still image to be superimposed.
7 Touch [ON], then .
8 Touch .
9 Press START/STOP to start recording.
The [M.OVRLAP] indicator stops flashing
and stays lit up, then disappears when fade
is completed.
Using special effects
— Digital effect
You can add digital effects to the recordings.
[STILL] (still)
You can record a movie superimposing it on a
previously recorded still image.
[FLASH] (flash motion)
You can record a movie with a serial-still-image
effect (Strobe effect).
[LUMI.KEY] (luminance key)
You can replace a brighter area in a previously
recorded still image, such as the background of
0:00:00
FADER: OFF
MONO-
TONE
OFF
MOSAIC
FADER
NORMAL
FADER
STBY 60min
0:00:00
P-MENU
NORMAL
FADER
STBY 60min
Still image Movie
, continued