Goulds Pumps 3180-86 - IOM - Manual (Page 90)

If your bearing frame is... Then...
Grease lubricated
Make sure that the plug (370E) is installed in the radial end oil return.
If you are changing the lubrication from grease to oil, remove the accumulated grease from the oil
return after you remove the plug.
5. Complete these steps if you removed the radial end cover (109A):
If your
pump
group
is...
Then...
S, M, L,
and XL
1. Degrease the surfaces and those in the frame.
2. Apply Loctite 518 to the outer diameter of the cover.
3. Tap the cover in place using a soft blow hammer.
XL1,
XL2-S,
and XL2
1. Degrease the surfaces and those in the frame.
2. Install the radial end cover gasket (360).
3. Install the radial end cover (109A) using the eight socket-head capscrews (370K) into
the frame (228).
228 360 109A 370K
6. Lightly lubricate the bearing bores (outer diameter of radial bearing), thrust bearing housing, and O-
ring with grease or light oil. Carefully insert the rotating element into the bearing frame.
Maintenance
88 Models 3180, 3181, 3185, and 3186 Installation, Operation, and Maintenance Manual