Assemble the stuffing-box cover – Goulds Pumps 3180-86 - IOM User Manual
Page 95
If your pump
group is...
Then...
XL1, XLS-2,
and XL2
Install the seal chamber (184) and hex head bolts (370H) on the frame adapter (108).
108
370H
418
184
351
126
6. Slide the cartridge seal on the gland studs and make sure that the tap connections are in the correct
orientation.
7. Hand-tighten the gland nuts.
8. Install the impeller and set the clearance.
9. Set the seal:
a) Tighten the set screws in the drive collar while the setting clips are engaged.
b) Tighten the gland nuts (355) evenly.
c) Disengage the setting clips.
Assemble the stuffing-box cover
WARNING:
Do not use packing that contains asbestos, it may cause personal injury.
1. Apply a liberal amount of an anti-galling compound, such as Loctite Nickel Anti-seize, to the bore of
the sleeve (126) and on the shaft (122).
2. Slide the sleeve onto the shaft.
3. Slide the throttle bushing (125) to the back of the shaft sleeve.
4. Use an eye bolt, strap, and sling as required.
5. Install the seal chamber (184):
Maintenance
Models 3180, 3181, 3185, and 3186 Installation, Operation, and Maintenance Manual
93