Goulds Pumps 3180-86 - IOM - Manual (Page 92)

1
1. Coupling guard end plate.
9. Lubricate the O-rings on the labyrinth oil seals.
10. Install the seal assembly into the bearing frame until the shoulders seat against the bearing frame.
11. Install these items on the bearing frame:
• Oil fill plug (408H)
• Shaft key (400)
• Coupling hub
• Frame foot (241)
12. Lubricate the bearing frame for grease or oil:
If you lubricate
with...
Then...
Oil 1. Install these four plugs (408C) as viewed from the coupling end:
• One on the left side of the frame (228)
• Two on the right side of the coupling end
• One at the stuffing box end at the top of the frame (228)
2. Install the oil level sight glass (319) on the right side of the frame (228).
3. If installing a sight oiler (251), install it on the left side of the frame as viewed
from the coupling end. Refer to separate instruction for sight oiler installation.
Grease (not
available for the
XL1, XL2-S,
and XL2
groups)
1. Install two grease fittings (193H) as viewed from the coupling end:
• One on the left side of the frame (228)
• One at the stuffing box end at the top of the frame
2. Install two plugs (408C and 408D) on the right side of the frame (228).
Maintenance
90 Models 3180, 3181, 3185, and 3186 Installation, Operation, and Maintenance Manual