Silverline Automatic Optical Level - Manual (Page 5)

4
GB
Specification
Image: ..................................................Erect
Magnification: ......................................X20
Objective Aperture: ...............................34mm
Field of View: ........................................1°20'
Minimum Focus: ...................................0.5m
Multiplication Constant: ........................100
Additive Constant: ................................0
Compensator Range: ............................±15'
Compensator Setting Accuracy: ............±0.8'
Sensitivity of Bubble: ............................8'/2mm
Horizontal Circle – Reading: .................1° or 1 gon
Instrument Net Weight: .........................1.55kg
As part of our ongoing product development, specifications of
Silverline products may alter without notice.
General Safety
Carefully read and understand this manual and any label attached to
the tool before use. Keep these instructions with the product for future
reference. Ensure all persons who use this product are fully acquainted
with this manual.
Even when used as prescribed it is not possible to eliminate all residual risk
factors. Use with caution. If you are at all unsure of the correct and safe
manner in which to use this tool, do not attempt to use it.
Trained, competent persons
• This tool should be used by trained, competent persons only
Children and pets
• Keep children and pets at a safe distance from the work area. Lock tools
away where children cannot gain access
Use the correct tool
• Do not force or attempt to use a tool for a purpose for which it was not
designed. This tool is not intended for industrial use
Keep your balance
• Do not over-reach. Keep proper footing at all times and do not use tools
when standing on an unstable surface
Accessories
• The use of any attachment or accessory, other than those mentioned in
this manual, could be dangerous and result in damage or injury, and may
invalidate your warranty
Never stand on your tool
• Standing on your tool or its stand could cause serious injury if the tool
is tipped or collapses. Do not store materials above or close to the tool
in such a way that a person might stand on the tool to reach the stored
items
Check for damaged or missing parts
• Before each use, check if any part of the tool is damaged or missing.
Carefully check that it will operate properly and perform its intended
function. Check alignment of moving parts for binding. Any guard or other
part that is damaged should be immediately repaired or replaced by an
authorised service centre.
DO NOT USE IF DEFECTIVE
Automatic Optical Level Safety
• Do not look through the lens directly towards the sun or into direct
sunlight as this could result in loss of eyesight. Always use a filter when
facing direct sunlight
Description of Symbols
The rating plate on your tool may show symbols. These represent important
information about the product or instructions on its use.
Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
633665_Z1MANPRO1.indd 4 26/10/2011 15:44