Festo Контроллер двигателя SEC-ST - Manual (Page 52)

3. Installation
3−10
Festo SEC−ST−48−6−P01−EN en 0606c
3.3.4 Connecting the SEC−ST to the power supply
1. Make sure that the power supply is switched off.
2. Insert the plug into socket X3 of the SEC−ST.
3. Connect the PE cable of the mains supply to the earth
terminal PE.
3.3.5 Connecting the SEC−ST to the controller (SPC200)
1. Make sure that the power supply is switched off.
2. Insert plug X1 into the socket on the SEC−ST.
3. Connect the earthing strap of the cable to the earth
terminal PE.
4. Insert the 15−pin sub−D plug connector into the stepper
motor control card socket.