Konica Minolta KIP 7000 - Manual (Page 104)

3-9 Section 3 ?” Screen
4.2 Power Save Settings
The KIP 7000 incorporates timers to save power and place the printer in “cold sleep mode”
to suit individual company production requirements. These timers can be used to
automatically turn off the printer when the “office is closed”, for example overnight.
Energy Star Settings – Energy Star compliant settings require that the printer goes to Warm
Sleep after 15 minutes and into Cold Sleep after 90 minutes of inactivity. These are the
factory setting and can be achieved by selecting “Reset”.
There are two sleep mode settings to choose from, only one can be active at a time and
these are locked by default in the Services settings.
1. Warm/Cold Sleep Timers – This timer can be set to put the printer into a warm/cold
sleep mode after a predetermined period of inactivity.
2. Sleep Time – This time is used in conjunction with the computers clock and is used
to put the Printer to sleep at a pre-set time and wake the printer back up at a pre-set
time.
Locked or Unlocked in “Service”
a) If the Timers are Locked they must first be unlocked in Service Menu (by a Certified
Service Technician)
b) Set the timers by pressing on the hour, minutes and AM/PM as needed.
c) If the printer is required during the “sleep” period, it will “awake”, produce the prints
and then “fall asleep“ again, 15 minutes later.
4.3 Default Mode
Sets which screen will be the default, Scan, Copy or Job Info
Mode dependent of the installation environment requirement.