Konica Minolta KIP 7000 - Manual (Page 66)

Section 1 Basic Printer Functions 1-60
Please check where the Paper Mis-feed has occurred referring to the following diagram.
(Greater detail on each code are on the following pages.)
NOTE
(1) Remove the mis-fed paper being careful not to cut your hand on the paper edge.
(2) Take off necklaces, bracelets, rings and wrist watch before removing the mis-fed paper.
Failure to do so may result in burns or electrical shock if the metal accessories touch the
interior of the printer.
(3) The toner image is not adhered correctly if the paper did not reach the Fuser Section.
Take care to ensure the toner does not rub onto your clothing when you remove the mis-
feed. If toner gets onto your clothing gently dust it off. If it does not dust off, was the article in
cold water. (Do not use hot water as it causes the fiber to absorb the toner.)
(4) The toner image is not adhered correctly if the paper did not reach the Fuser Section.
Take care to ensure that toner does not get into your eye, and take care not to inhale the
toner. (Please flush the contaminated area with water if toner gets into your eye or mouth.)
Roll 1 Roll 2
Roll 3 Roll 4
Outer Device
(Auto Stacker,
Folder, etc.）
J-21、J-22
J-12 J-13、J-14 J-11
J-05
J-10
J-01
J-02
J-03
J-04
Front Rear