Konica Minolta KIP 7000 - Manual (Page 233)

7-21 Section 7 KIP Print Net
• Reprint
Sets the number of copies to reprint after a jam condition. This value is used
as default.
Sets the number of inches to reprint after a jam condition. If a value is set
here it will override the default copies to reprint.
Advanced Configuration
• Print Separator Sheets
Sets where separator sheets are printed.
• Deck Info
Sets Media selection. Custom Media Types can be added here.
• Other
Min Cut Length – Sets the minimum length a sheet can be cut to, measured
in Inches. Default 8.25”.
Max Image Length – Sets maximum image length that can be printed,
measured in Inches. Default 600”.
HPGL Min Line weight – Sets the minimum line weight for HPGL pens,
measured in Inches. Default .003”.
HPGL Min Grayscale – Sets the minimum setting for grayscale. Default 1.
DWF Min Line weight – Sets the minimum line weight for DWF images.
Default 1.
Image Width Removal – Sets how much with of the image is removed,
measured in pixels. Default 75.
Lead Edge Void – Sets the amount of the leading edge is ignored, measured
in pixels. Default 50.
Delay Between Collated Sets – Sets the print delay in between collated sets,
measured in seconds. Default 1.
• Custom Media Types
Lists and sets Media Types.