Konica Minolta KIP 7000 - Manual (Page 57)

Section 1 Basic Printer Functions 1-51
3. 2. 8 User Mode 7: Warm Sleep Setting Mode
Please Set in the Touchscreen - “?”
Keep this mode always “oFF”. (Do not change this setting.)
It is possible to select whether the Warm Sleep function works or not on the User Interface (UI).
The purpose of Warm Sleep Mode is to reduce the power consumption by falling down the
temperature of heater some degrees.
The temperature of the heater unit is about 150 degrees Centigrade when the KIP 7000
is ready. But if no print job or copy job is sent for a long time, it is better for saving the power
to fall down the temperature of heater. (Temperature is kept about 120 degrees Centigrade.)
The Warm Sleep Mode will be cancelled automatically if only you send a print job or a copy
job from the outer device.
However, please understand it takes some minutes to recover from the Warm Sleep Mode
because it is necessary to raise the temperature again up to about 150 degrees Centigrade.
(Print does not start until the KIP 7000 gets ready.)
Reference