Konica Minolta KIP 7000 - Manual (Page 226)

7-14 Section 7 KIP Print Net
c) Media type
Available media types ‘Bond’, ‘Vellum’, ‘Film’ are defined within Winreq.ini
KIP PrintNET software will use the media types tables defined in winreq.ini
Winreq.ini can be edited to allow more media types. An example showing an
additional defined media ‘TBond’ is shown below. Up to six (6) character long names
can be chosen for Media types. To edit, open Winreq.ini on the Host PC and scroll to
the following lines
[PaperTypes]
Paper0=Bond
Paper1=Vellum
Paper2=Film
Paper3=TBond
d) Stamp
Available stamps are created and defined within KIP Request. KIP PrintNET
software will use stamps defined in KIP Request.*
Please refer KIP Technical User Guide for KIP Request software for more
information on pen table setup
e) Rotate / Fold
Available Rotate / Fold parameters are defined within KIP Request. KIP PrintNET
software will use Rotate / Fold parameters defined in KIP Request.*
Please refer KIP Technical User Guide for KIP Request software for more
information on Rotation and Fold parameters
f) Enlarge / Reduce and Force -Size settings
Standard enlargement and reduction ratios 25%, 50%, 66.7%, 75%, 150%, 200%
and 400% are non-modifiable. Additional Force-Size settings are created and
defined within KIP Request. KIP PrintNET software will use Force-Size settings
defined in KIP Request.*
Please refer KIP Technical User Guide for KIP Request software for more
information on Force-Size settings