Konica Minolta KIP 7000 - Manual (Page 155)

Section 5 AutoCAD Driver 5-17
5.5 Color Merge Control
Color merge is the prevention or selection of a third color (or shade when
printer on the KIP 7000) where layers of a drawing overlap.
Color Overwrite Color Merge
5.6 Adjustments
5.6.1 Line Width Compensation
Controls line weights on a global basis. Values can be from -4.0 to +4.0. A
higher value will result in all lines increasing in thickness. A lower value will
result in all lines decreasing in thickness.
5.6.2 Vector Line Dither
Controls dithering patterns for grayscale line entities. Values are from Fine
(Tight) to Coarse (Wide) dither patterns.
Note
This does not control vector fill areas. This should be set at the KIP IPS
5.6.3 RTL Image Dither
Works in conjunction with Raster Image Control: if Raster Photo Mode is
enabled, then RTL Image dither can be controlled. Values are from Fine
(tight) to coarse (wide) dither patterns. Photographic images work best with a
more coarse setting while embedded text documents from Word or Excel
work best with a Fine setting.