Konica Minolta KIP 7000 - Manual (Page 56)

Section 1 Basic Printer Functions 1-50
3. 2. 7 User Mode 6: Warm Sleep Timer Setting Mode
Please Set in the Touchscreen - “?”
Do not change this setting.
It is possible to change the timer for the Warm Sleep function on the User Interface (UI).
1. The purpose of Warm Sleep Mode is to reduce the power consumption by falling down
the temperature of heater some degrees.
The temperature of the heater unit is about 150 degrees Centigrade when the KIP 7000
is ready. But if no print job or copy job is sent for a long time, it is better for saving
the power to fall down the temperature of heater.
(Temperature is kept about 120 degrees Centigrade.)
The Warm Sleep Mode will be cancelled automatically if only you send a print job or
a copy job from the outer device.
However, please understand it takes some minutes to recover from the Warm Sleep Mode
because it is necessary to raise the temperature again up to about 150 degrees
Centigrade.
(Print does not start until the KIP 7000 gets ready.)
2. When both the Cold Sleep Function and the Warm Sleep Function are effective, their
functions work as follows; (Both timers start simultaneously.)
As for the Cold Sleep Function, refer to page 3-9 to 3-10.
<Example 1>
In case that the Warm Sleep Timer is 15 minutes and the Cold Sleep Timer is 30 minutes,
the printer will go into the warm sleep mode in 15 minutes after printing.
And it will also go into the Cold Sleep Mode in 15 minutes after the printer goes into
the Warm Sleep Mode.
<Example 2>
In case that the Warm Sleep Timer is 30 minutes and the Cold Sleep Timer is 15 minutes,
the printer will go into the Cold Sleep Mode in 15 minutes after printing.
In this case, the Warm Sleep Function does not work.
Reference