Sharp UP-600 User Manual
A) RETRY command (selection from the menu or press of the 1 key)
B) ABORT command (selection from the menu or press of the 2 key)
C) IGNORE command (selection from the menu or press of the 3 key)
(* If there is only RETRY and IGNORE on the menu, press the 2 key.)
A) RETRY command:
When RETRY is selected, the master attempts a RETRY to the satellite; however, it does
not retry when, due to the type of error (for example, command error), it is obvious that the
RETRY will fail. This means that the master will not gain access if errors that have occurred
during transmission are such types of errors.
B) ABORT command:
When ABORT is selected, the master terminates access to the satellite and regards the
transmission as having unsuccessfully ended. However, in the case of program data
downloading, the ABORT command may be issued only when all the satellites accessed are
in the error state.
C) IGNORE command:
When IGNORE is selected, the master terminates access to the satellite, regards the
transmission as having successfully ended and prints only transmitted data.
If no satellites have successfully transmitted data, the IGNORE command may be issued to
the master in the case of sales data inquiry (X report), though the result is not printed.
[Retry during sales data inquiry]
During resetting, the CANCEL command may be given only when every accessed satellite is
in the error state. The IGNORE and RETRY commands are available unconditionally.