Apple AppleVision 1710AV - Manual (Page 120)

2 Plug the connector (marked by
_
) on the sound cable into the sound output port on
your computer.
The connector (marked by
_) fits most standard speaker jacks. The sound
input port on your computer may be located on a sound or multimedia card.
Connecting sound input equipment to your display
To record sounds, you can use the built-in microphone on your AppleVision
1710
AV Display, or you can connect external sound input equipment (such as
an audio CD player, cassette player, or external microphone) to the display.
To connect sound input equipment:
1 Make sure the connector (marked by
≈
) on the sound cable is plugged into the sound
input port on your computer.
2 Plug the equipment into the sound input port (marked by
≈
) on the left side of the
display.
Note: To use sound input equipment (such as an audio CD player, cassette
player, or external microphone) you must select the correct sound input
source on your computer. See the manual that came with your computer.
Connecting sound output equipment to your display
If you wish, you can plug a pair of headphones (or other sound output
equipment) into the AppleVision 1710
AV Display. To plug your headphones
into the display, follow these steps:
1 Make sure the connector (marked by
_
) on the sound cable is plugged into the sound
output port on your computer.
2 Plug the headphones into the sound output port (marked by
f
) on the right side of the
display.
3 Before using the headphones, check the volume to make sure it’s not too loud.
WARNING Be careful not to plug your headphones into the sound input
port (marked by
≈). Doing so may damage your audio equipment.
123 Setting Up for IBM PC-Compatible Users