IKA C 6000 isoperibol Package 2/12 - Manual (Page 12)

12
Connection to the condenser
Make sure the fi lter casing is always
securely closed (see „Servicing and
cleaning the fi lter“)!
Insert the infl ow pipe into the „IN“
port until it clicks home. Connect the
other end of the pipe to the „OUT“
port of the condenser (water pressure
max 1.5 bar).
Insert the return pipe into the „OUT“
port until it clicks home. Connect the
other end of the pipe to the „IN“ port
of the condenser.
The connection „EMPTY“ is intended
only for emptying the device, e.g.
for transport purposes. In normal
operation the discharge hose need not
be inserted!
Rear view without hoses attached
Commissioning
Connection to the water
Operatrion is only allowed with the
pressure valve IKA ® C 25!
The IKA ® C 25 pressure valve is
absolutely essential on the water
faucet for operation of the calorimeter,
and it must be preset to an output
pressure of approximately 1.5 bar.
The valve is installed into the line of
the water connection, see operating
instruction IKA ® C 25.