JLG 1850SJ Service Manual - Manual (Page 231)

SECTION 5 - BASIC HYDRAULIC INFORMATION & HYDRAULIC SCHEMATICS
3121619 – JLG Lift – 5-61
Installation
1. Carefully insert the sensor into the cylinder. It may be
necessary to gently tap the end of the sensor to seat the
o-ring into the sensor bore. DO NOT tap on the wiring
harness.
2. Install the cap and secure in place with the retaining
bolts.
3. Apply lubricant JLG P/N 3020039 to the setscrew and
install the setscrew. Torque the setscrew to 4 in. lbs. (0.45
Nm).
4. Install the plug over the setscrew.
5. Raise the cylinder back in place and install the retaining
pin.
6. Install the keeper pin and retaining bolt.
7. Check the cylinder for proper operation.