JLG 1850SJ Service Manual User Manual
Page 291
SECTION 6 - JLG CONTROL SYSTEM
3121619
– JLG Lift –
6-9
ENGINE SHUTDOWN:
7
0
1
DISABLED: No engine shutdown.
ENABLED: Shutdown engine when coolant temperature is greater than 110 deg. C or the oil
pressure is less than 8 PSI.
1
FUEL CUTOUT:
8
0
1
2
RESTART: Engine allowed to be restarted multiple times when very low fuel level is reached
ONE RESTART: Engine allowed to be restarted once for 2 minutes when very low fuel level is reached
ENGINE STOP: Engine not able to restart when very low fuel level is reached
0
TILT:
9
1
2
3
4
5
6
5 DEGREES: Reduces the maximum speed of all boom functions to creep when tilted more
than 5 degrees and above elevation; also reduces drive speed to creep.
4 DEGREES: Reduces the maximum speed of all boom functions to creep when tilted more than 4 degrees
and above elevation; also reduces drive speed to creep.
3 DEGREES: Reduces the maximum speed of all boom functions to creep when tilted more than 3 degrees
and above elevation; also reduces drive speed to creep.
4 DEGREES + CUT: Reduces the maximum speed of all boom functions to creep when tilted more than 4
degrees and above elevation; also disallows tower lift up, tower telescope out, drive, main telescope out
and main lift up.
3 DEGREES + CUT: Reduces the maximum speed of all boom functions to creep when tilted more than 3
degrees and above elevation; also disallows tower lift up, tower telescope out, drive, main telescope out
and main lift up.
5 DEGREES + CUT: Reduces the maximum speed of all boom functions to creep when tilted more than 5
degrees and above elevation; also disallows tower lift up, tower telescope out, drive, main telescope out
and main lift up.
1
Note: Any of the selections above will light the tilt lamp when a tilted condition occurs and will sound the platform alarm when the machine is also above elevation.
JIB:
10
0
1
2
NO: No Jib installed.
YES: Jib installed.
SIDESWING: Jib with Sideswing installed.
2
4WS:
11
0
1
NO: 2WS mode enabled.
YES: 4WS mode enabled.
1
Table 6-2. Machine Configuration Programming Information
Configuration Digit
Number
Description
Default
Number