JLG 1850SJ Service Manual User Manual
Page 292
SECTION 6 - JLG CONTROL SYSTEM
6-10
– JLG Lift –
3121619
DRIVE:
12
0
1
2WD drive mode enabled.
4WD drive mode enabled.
1
STOUCH/SKYGUARD:
13
0
1
2
3
None: No soft touch or SkyGuard system installed.
SOFT TOUCH - Soft touch only installed.
SKYGUARD - Skyguard only installed
BOTH(CUTOUT) - Soft touch and Skyguard installed
0
GEN SET/WELDER:
14
0
1
2
NO: No generator installed.
BELT DRIVE: Belt driven setup.
HYDRAULIC DRIVE: Hydraulic driven setup.
1
GEN SET CUTOUT:
15*
0
1
MOTION ENABLED: Motion enabled when generator is ON.
MOTION CUTOUT: Motion cutout in platform mode only.
0
* Only visible if Gen Set / Welder Menu selection is not 0.
H & T LIGHTS:
16
0
1
NO: No head and tail lights installed.
YES: Head and tail lights installed.
0
LOAD SYSTEM:
17*
0
1
2
3
4
NO: No load sensor installed.
WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps (5 sec ON, 2 sec OFF).
CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm beeps (5 sec ON, 2 sec OFF).
CUTOUT ALL: All functions cutout, flash overload light (500mS on, 500mS off), platform alarm beeps (5
sec ON, 2 sec OFF).
SPECIAL 1: Functions in creep, overload lamp lit, disables main telescope out & main lift up, platform
alarm beeps (5 sec ON, 2 sec OFF).
0
* Only visible under certain market selections.
* Certain market selections will limit load system options or alter default setting.
Table 6-2. Machine Configuration Programming Information
Configuration Digit
Number
Description
Default
Number