JLG 1850SJ Service Manual - Manual (Page 325)

SECTION 6 - JLG CONTROL SYSTEM
3121619 – JLG Lift – 6-43
Sensor #8 - Jib Stow Angle Sensor (1)
See (See Figure 6-23.)
This sensor is used to measure Jib swing angle. This is a rotary
sensor mounted to the underside of the Jib Pivot weldment. It
is a dual output sensor in a single mechanical body with elec-
trically opposing signals.
Sensor #9 - Jib Lift Angle Sensor (1)
This sensor's function is to measure the Jib angle relative to
the Main Boom Pivot weldment. A linear position sensor is
located inside the Jib lift cylinder to measure cylinder stroke.
Torque 34 Nm
ANGLE
SENSOR
ANGLE
SENSOR PIN
SENSOR MOUNT
SENSOR
BRACKET
ADAPTER
SCREW, WASHER,
THREADLOCKER
P/N-0100035
SCREW,
THREADLOCKER
P/N-0100035
BOLT, WASHER
THREADLOCKER
P/N-0100011
Figure 6-23. Jib Stow Angle Sensor