Shaft & front bearing -29, Swash plate & servo piston -29 – JLG 1850SJ Service Manual User Manual
Page 71
Advertising
SECTION 3 - CHASSIS & TURNTABLE
3121619
– JLG Lift –
3-29
.
Figure 3-24. Shaft & Front Bearing
20.
Remove inner snap ring (35) and shaft/bearing assembly.
21.
Remove snap-ring (36) retaining shaft front bearing. Pull
bearing (37) off shaft (38).
Figure 3-25. Swash Plate & Servo Piston
22.
Turn housing over and remove swashplate (39) by lifting
on end opposite servo lever.
23.
Remove servo piston (40). Remove piston seal (41) and
O-ring (42) from servo piston. Discard seal and O-ring.
24.
Remove journal bearings (43) from housing. Note loca-
tion and orientation of each bearing for reassembly.
35. Inner Snap Ring
36. Snap Ring
37. Bearing
38. Shaft
38
37
36
35
39. Swashplate
40. Servo Piston
41. Piston Seal
42. O-ring
43. Journal Bearings
41
42
40
Lift Here
39
43
Advertising