JLG X19J Operator Manual - Manual (Page 15)

There is a control position available only for scheduled and unscheduled maintenance opera‑
tions, placed near the electrical components compartment on the machine.
At the rear of the electronic board protection box there is an auxiliary connector for attaching
the optional second remote control (see photo).
To enable this position, use the key selector placed on the base of the turret and connect the
optional second remote control to the machine.
Before proceeding with the connection, carefully read the paragraph regarding the use of
the optional second remote control.
This control position can only be used to carry out checks and maintenance on the machine.
Do not use this position to control the machine during normal operations.
Note: it is absolutely forbidden to move the machine from this position if one ore more
operators are in the basket.
ATTENZIONE
PHOTO 1 PHOTO 2
OPTIONAL SECOND REMOTE
CONTROL CONNECTOR POSITION OPTIONAL SECOND REMOTE
CONTROL CONNECTOR
X19JR0620113
BOOM LIFT MODELS X19J
JLG
11
WARNING