JLG X19J Operator Manual - Manual (Page 63)

valve can only be enabled if all the conditions that allow the movement of the aerial part
have been satisfied.
This is signalled by the icon on the remote control in position 5, and repeated on this
panel by the green light coming on (see photo).
3_Turning the key anticlockwise enables the control position for maintenance using the
remote control on the ground; this option can only be used for maintenance operations
and for it to be enabled the primary remote control must be in the basket or the remote
control cable in the basket must be connected to the special adapter.
‑ Emergency STOP. If pressed stops the motor and stops the machine. To make the machi‑
ne operational again, the button must be turned and released.
‑ START BUTTONS: Enable the selected engine/motor to be started, provided that all the
emergency stop buttons have been released and all the conditions necessary for the start
of the engine/motor are satisfied.
CONNECTING THE REMOTE CONTROL TO USE IT FROM THE GROUND
The remote control in the basket (or an optional second remote control) can be used for
maintenance operations by connecting it to the special socket on the machine.
To do this, proceed as follows:
‑ With the machine off (key in position OFF), connect the remote control to the special
cable located near the electrical components compartment under the protective cover.
‑ Select control from the ground using the key on the control compartment.
‑ If using the remote control provided in the basket as the control device from the ground,
connect the free cable in the basket to the special connector to be found together with the
maintenance and emergency devices inside the electrical components compartment.
‑ Turn the key to position ON and start the machine.
The remote control can be used from the ground to perform all possible operations within safety
limits if the load in the basket is less than 50 kg. If the load in the basket exceeds 50 kg (always
within the machine’s load limits), in order to be able to use the remote control from the ground
hold button 8 and activate the desired control.
IT IS STRICTLY FORBIDDEN TO USE THE REMOTE CONTROL FROM THE GROUND TO
MOVE THE MACHINE WHEN AN OPERATOR IS IN THE BASKET.
PERICOLO
X19JR0620113
BOOM LIFT MODELS X19J
JLG
59
DANGER