2N VoiceBlue MAX v1.5 - Manual (Page 48)

48
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Tones generated to VoIP
Ring tone to VoIP – generate a ringing tone of your own, or transmit a real
ringing tone from the GSM/UMTS networks.
FXS Interface
Profiles
Line impedance profile – select right impedance of analogue line (according to
region where is the gateway installed)
Ring profile – select right type of ringing profile (pattern, voltage, frequency)
- (according to region where is the gateway installed)
Tone profile – select right type of ringing tone (according to region where is the
gateway installed)
Call ID profile – select right type of Call ID profile (FSK mode) - (according to
region where is the gateway installed)
Functions
Day of deleting statistics (every month) – the day of automatic deletion of call
statistics on the VoIP interface. None = no deletion
Tariff pulse type (metering) – possibility to set-up metering pulses sending
(Disabled/12kHz/16kHz)
FXS line selection for incomming calls – selection of destination FXS line(s) in
case of incomming calls from VoIP or wireless networks
DTMF detector during call enabled – enables/disables DTMF detection during
connected call
Volume settings
Analog to digital gain [dB] – Voice processing settings
Digital to analog gain [dB] – Voice processing settings
Tip
Should there occur call errors (one-way audibility, connection errors,
e.g.), check the settings of all active elements on the VoIP call route. To
detect the problems quickly, you can test the Point-to-Point connection
with a software IP phone (SJ phone, e.g.) in your PC and use tracing by
means of a network analyser (WireShark –
e.g.) at www.wireshark.org
the same time.
Refer to
for easy tracing through . Subs. 4.2 2N VoiceBlue
®
MAX
Caution
Internal CLIPs for FXS ports are: FXS0–100; FXS1–101; FXS2–102;
FXS3–103