2N VoiceBlue MAX v1.5 - Manual (Page 54)

54
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Basic settings
Roaming enabled for network code – set the international network identifier for
roaming purposes consisting of the following two codes:
MCC – Mobile Country Code – country code (Czech Republic – 230);
MNC – Mobile Network Code – GSM code (T-Mobile – 01, 0202, Vodafone –
03).
Hence, the international identification code for T-Mobile CZ is 23001. Leave this field
empty to disable roaming.
String Note
<empty> Roaming is disabled
2300 Roaming is disabled (5 digits is the minimum count)
23002 Roaming is enabled for networks with MCC+MNC code 23002
230XX Roaming is enabled for networks with MCC+MNC codes 23000 – 23099
XX001 Roaming is enabled for networks with MCC+MNC codes 00001 – 99001
XXXXX Roaming is enabled for any network
CLIR – fill in this parameter to define whether or not the called subscriber should
be displayed the calling SIM card telephone number. It is recommended that the
telephone number of the SIM card inserted in the GSM module should not be
displayed to the called subscriber to avoid problems with CallBack from GSM.
Maximum count of called minutes – set the maximum count of minutes to be
used via the SIM card per month.
Count of SMS messages – set the maximum count of SMS messages to be sent
via the SIM card per month.
Day to restore call limit and delete statistics – set the day in a month on which
the statistics of the
a Maximum count of called minutes Count of SMS
parameters should be deleted messages .
First count – set the length of the first pulse after which the pulse counting will
be changed as set in the
parameter Next count .
Next count – set the length of one pulse in seconds after the time as defined in
the
parameter elapses First count .
Note
Check the GSM/UMTS searching priorities on the SIM card using your
mobile phone before enabling roaming.
Caution
Calls via a roaming network may increase you telephone bill!
Caution
The and enable services must be Temporary CLIP Temporary CLIR
supported by the GSM/UMTS provider. If not, not, the provider's network
may reject the call!